But there are a few reasons you should consider adding the bench to your pectoral workout, or adding to your existing routine.
1 It provides a measure of your upper body strength
2 It builds your pecs like no other exercise
3 It can carve out your cleavage
Those reasons in tow, and assuming they provided enough motivation, let's move on to the program, shall we?
Your Power Plan
In a mere eight weeks, you can go from a benching beginner to a pressing pro with this program. The key is a typical powerlifting technique - which sounds a lot scarier than it is. Basically, it involves progressively increasing the weight you're lifting while decreasing the number of reps you perform each set, starting with 10 reps per set with your lightest load and going all the way down to four reps per set with your heaviest weight. Choose a weight that allows you to finish the prescribed number of reps - no more, no less.
Weeks Exercise Sets/Reps Rest Time
1-2 Bench Press 4/10 2-3 min.
Incline Bench Press 3/10 2-3 min.
Incline Dumbbell Flye 3/10 1-2 min.
3-4 Bench Press 4/8 2-3 min.
Incline Bench Press 3/8 2-3 min.
Cable Crossover 3/12 1-2 min.
5-6 Bench Press 4/6 2-3 min.
Incline Bench Press 3/6 2-3 min.
Machine Flye 3/15 1-2 min.
7-8 Bench Press 4/4 2-3 min.
Incline Bench Press 3/4 2-3 min.
Incline Dumbbell Flye 3/20 1-2 min.
ANGLING FOR GAINS>> Incline: Set the backpad at a roughly 45-degree angle. This focuses on your upper chest.
>> Flat: The angles of the back and seat are zero. This targets the lower pecs more and is the most natural-feeling and therefore easiest of the three bench positions.
>> Decline: The angle of the backpad is at a decline of about 30 or 40 degrees. Although this press is the most awkward for beginners to master, you'll actually be stronger on the decline because it demands a shorter range of motion and the large lat muscles are more involved.
FORM COUNTS
>> These instructions apply to a bench or a Smith machine:
1) Lie faceup on the bench with your knees at a 90-degree angle and feet flat on the floor, wider than shoulder-width apart. This helps stabilize your body on the bench.
2) Arch your back slightly, keeping your shoulders and glutes pressed into the bench, and grasp the bar so that your hands are just outside shoulder width. You'll know your grip is correct if both elbows form 90-degree angles when you lower the bar.
3) Make sure you wrap your thumbs around the bar (which will prevent you from flexing your wrists) and squeeze tightly. This ensures that the force exerted by your pecs, delts and triceps travels more efficiently to the bar.
4) Unrack the bar and hold it, arms fully extended, at the starting position that corresponds to the exercise you're doing: over your upper chest on an incline bench, over your middle chest for flat bench, over your lower chest for decline.
5) Inhale deeply and hold your breath. Squeeze your shoulder blades together and slowly lower the bar toward your chest. At the lowest position, it should touch the level of your chest that corresponds with the angle of the bench (upper for incline, mid for flat, lower for decline).
6) To fully recruit all those meaty muscle fibers, you need to force the bar back up as powerfully as possible. Imagine it's as light as a feather and press it straight back up in as quick, strong and fluid a movement as possible. Exhale at the top. HERS
RELATED ARTICLES:
HOME INTENSITY BOOSTERS
MORE SMASH HITS
LOWER BODY BOOT CAMP
COUNTDOWN TO ABS
